Looked at another problem solving example on power dissipation on a linear resistor and went back to dig deeper on understanding power in battery and when it is discharging or recharging.
Power when recharging is positive wattage while discharging it is negative wattage and from there we can infer if the current in amperes must be negative or positive.
Insight on using kirchhoff’s law on a negative current result implying that earlier assumption of the current direction is wrong and so the sign of the current must be flipped.
Another insight on calculating total power in a circuit in relation to conservation of energy. All power from different elements in the circuit must equate to zero.
In the case of two batteries in a series circuit with a resistor in the middle, energy is moving away from the higher voltage battery to the lower voltage battery but the calculations imply a missing energy amount after it left the battery with the highest voltage, that energy didn’t transfer to the lower voltage battery but was dissipated as heat by the resistor in between.
Hence, while the power for both the batteries involve the equation P = VI, the resistor in the middle calculates it as square of current that’s passing thru the resistor over the resistance of the resistor.
While one of the difficult courses in computer science was the computational complexity theory, in electrical engineering it is circuit analysis both for DC and AC, and I remember the tons of problem solving that we had to do in circuit analysis on Circuits - 1 back at the local BSEE program, it was horrific. All of us there was pulling our hair for the whole semester. It is an illusion to think that circuit analysis is just Ohms law 🤣.
This site will hold short thoughts, daily observations, technical discoveries, project progress, and records that do not require a full article.